AMS 2-Tier stand V6.0 + Braces + Plate holder

A full set of upper and lower braces for the 2-tier AMS setup, specifically modelled for the newer V6.0 AMS units. My unit had a manufacturing date around December '23 - however, none of the existing braces were a clean fit. The existing V6.0 models were a very tight fit and were missing the tops.

Also included are a set of braces with optional plate holders built-in. These angle the plates for easy access but aren't required.

• Full upper and lower set of braces for V6.0 (72mm/73mm/72mm).
• Is a clean fit (other options had interference issues)
• Optional braces for either side
• Optional plate holders for either side
• Uses 2020 Extrusion
• 400mm, still allows the lower AMS to open - but not completely. 420mm, allows lower AMS to fully open.

Thanks to;

• Roger Reid for the initial modelling
• SThane for the brace and plate holder inspiration
• Ronncat for the initial V6 models

Design by Cadr3D on MakerWorld (license: BY-SA).