Bambu Studio PETG Temperature Test Tower
Bambu Studio PETG Temperature Test Tower
This PETG temperature tower is adapted from OrcaSlicer's built-in calibration model and tuned to also work reliably in Bambu Studio. It prints a stack of blocks, with the nozzle temperature stepping up at each level, so you can test a range of temperatures in one print and find the best setting for your PETG filament and printer.
What to check on each block:
- Stringing – fine hairs between features (usually worse at higher temps)
- Layer adhesion – how well layers bond together
- Extrusion – smooth, consistent walls vs. under/over-extrusion
- Bridging – sag or drooping on bridged sections
- Surface finish – gloss, texture, blobs, or zits
The best temperature is usually the block with minimal stringing, clean bridging, and strong layer bonding — without the excess gloss or oozing that comes from running too hot.
The included 3MF file works in both Bambu Studio and OrcaSlicer. This design has been tested through 6000+ successful calibration prints across multiple filaments and printers (per MakerWorld data), giving consistent, repeatable results. It's a quick way to dial in PETG, PETG-HF, and PCTG profiles before starting longer prints.
Picking your temperature: If several temperatures look good, pick the middle one for balance. For higher flow rates or faster speeds, lean toward the higher end for better layer bonding and extrusion stability.
This remix follows the AGPL-3.0 license of the original asset, includes all source files, and provides full attribution to OrcaSlicer: https://github.com/OrcaSlicer/OrcaSlicer and gaaZolee: https://www.thingiverse.com/gaaZolee/designs
More Temperature Towers
Thanks for downloading and I hope this was useful to you. Please leave an honest review or comment with any concerns regarding the model or profile. Thanks and have a wonderful day!
Design by Fragmented on MakerWorld (license: BY-SA).