Hands-Free Book Holder

Summary

The base must be printed so the parts with holes are flat on the bed! This will make the part have best strength.

Do you like to read while you eat? Do you often have a cookbook open while making recipes? Do you have an open manual while building a 3D printer or other device? Are you frustrated with these books closing on you, losing your page and disturbing your activity?

This device will solve these problems. Easy to print, easy to assemble, and easy to use, just push down the levers and insert your book, and the Hands-Free Book holder will clamp the book open in exactly the spot you want!

I love to read while eating, and I grew frustrated with the book closing on me if I needed two hands while eating. This holder allows me to enjoy my reading lunches in peace.

Print Settings

• Notes:

  Pieces required

  • 1 X Base, either
    • Book Holder Base i2 No Text.stl; or
    • Book Holder Base i2 With Text.stl; or
    • Book-holder-base (older version);
  • 1 X Book Holder Snap Piece Left i2.stl
  • 1 X Book Holder Snap Piece Right i2.stl

  General: I suggest printing the i2 version, as it works better than the original. For all pieces there is no supports needed. Use 3 perimeters for better strength, and at least 15% infill. Otherwise, anything goes! PETG and PLA both work great.

  Book holder base: Orient so the side with the holes is on the bed for maximum strength.

  Book holder snap piece: Orient so the entire L is on the bed. NOTE: The pegs are flush to one side of the piece, so ensure the pegs on the piece are flat against the bed, otherwise they will print in the air and not be as good quality.

Post-Printing

Assembly

Line up an arm so it's almost perpendicular with the base piece, with the L part of the arm high up, facing the BOOK logo. Insert the lower pin on the arm into the higher hole on the base piece. Rotate the arm down towards the side, and flex the piece apart to insert the second pin. Repeat with the other arm. To use, pinch the middle two arms, which will flex them so you can insert a book. When you release it will keep your book open on that page.

Creators: https://www.thingiverse.com/cfisch06/designs

 

Design by lancelotcv on MakerWorld (license: BY-SA).