Lack Table Leg Extension 150mm for Print Enclosure

My Elegoo Neptune 3 Pro didn't fit under the IKEA Lack Side Table I purchased to make an enclosure. Therefore I made these leg extenders. They are 50mm thick, just like the Lack legs, and 150mm tall. Partially hollow with a large hole that is built to fit a screwdriver, so you can use the small hole at the bottom to screw the leg extender into the leg with a wood screw. Finished off with a 2mm shelf around the edge to keep it square against the leg. 

Design by FirkwithaD on MakerWorld (license: CC0).