Motherboard control board Fan Mount For P1Pand P1S

This mod is used to mount your motherboard fan so that it takes fresh cooler air from vent holes and pushes it on the hot motherboard and its heatsink.

I printed this one in ABS, i suggest printing in PETG, ABS, ASA, PC, PA, i STRONGLY ADVISE AGAINST printing in PLA, it wont hold and it might melt!!

Original fan location is double sided taped on the side of the printer, which still confuses me, basically suffocating the fan, 0 airflow, in the end either cooking the fan or the motherboard. 

You mount this on top of the POOP chute it can stand there or you can add some double sided tape to hold it stronger, mount the fan on the specific location and screw it or tape it.

It will allow the fan to pull cooler air from outside on top of the heatsink. Hopefully lowering the chance of either going bad or at very least extending the life of both.

I would like to thank the original creator: https://www.printables.com/model/465993-fan-mount-mcu-bambu-lab-p1p

i modified the file and added supports and brim for ABS printing.

Design by secretboy on MakerWorld (license: BY).