Pegboard Headphone Holder (6mm / 16mm)

A curved headphone hanger designed for metal pegboards with 6mm holes and 16mm hole pitch.

Note: This is for metric 6mm/16mm boards (common on desk-mounted metal pegboards), not standard 1/4-inch × 1-inch pegboard.

Features:

• Wide, saddle-shaped cradle spreads the load across the headband — no pressure points or dents in the padding, even on soft leather/pleather headbands
• Curved wings keep the headphones centered so they won't slide off
• Four-peg mount for a secure, wobble-free fit
• Reinforced gusset bracket handles heavier headphones (studio cans, wireless over-ears with battery)

Printing & Assembly:

• Prints in 2 pieces, joined with a dowel — everything is already set up in the 3MF, just slice and print
• No supports or extra hardware needed

Compatibility:

• Pegboards with 6mm diameter holes and 16mm spacing
• Fits over-ear and on-ear headphones of any headband width

Installs in seconds — shown in the photos holding a full-size wired studio headset with room to spare.

Design by James Tran on MakerWorld (license: BY-SA).