This is a center console tray (with coin tray) remix from jonco223's design. The original design is great but I just have some pet peeves that I needed to modify...

The following are the modifications:

1. Fix - The wall thickness below the coin tray is too thin for 0.4mm nozzle to print, I was getting a pin-hole in my original print.

2. Fix - The step-down from the top ledge is rubbing against the center console cover. I recessed it back 10mm. This problem will show up if you plan on flocking the tray - the rubbing will rub off the flocking fibers and the paint.

3. Mod - Added a partial opening in the front of the tray to allow cable or light to come thru from the bottom of the center console.

4. Mod - Rounded out most of the straight edges in the tray as (and I'm still learning) sharp corners don't stick to flocking fibers too well.

JGAurora A5

No

30%