Butterfly Stained Glass/Sun Catcher

I recently saw the new translucent PLA advertised from Bambu.  I thought I'd give it a try and ordered 3 colours.  I didn't dry it first, as was recommended, I have it in the dryer now.  I did experiment with some settings and followed Bambu Wiki suggestions on printing with this filament.  I tried 100% infill, no top or bottom layers, 0% infill. I found 100% infill with 3 top and bottom layers, 1 wall seems to work best.  I also tried scaling the prints to find different amounts of light diffused.  I liked 1.75mm, however you can easily adjust the z height to make it more or less translucent.  You can also easily add or change the colours, like I said, I only purchased 3 to start with. just make sure to either paint both sides, or colour by object, otherwise it will only change the colour on one side.  Also, CLEAN THE BED!  I did have some adhesion issues, even after a good clean with Dawn dish soap.  

Design by Picture_it on MakerWorld (license: BY-SA).