DIN rail mount | DIN-Schienenhalterung

Thanks to Francesc for the original, which I adapted.

This bracket is for 35 mm DIN rails. There are two holes for M5 Spax screws. The infill around the holes has been increased. 
Compared to the original version, I have adjusted the height to 20 mm. This has made the spring mechanism very stiff (which is good, as it lifts very well). Nevertheless, I have provided two small recesses to make it a little easier to operate.
The print runs at 124% on my printer (P1S with PETG) without any problems.
Have fun and good luck!

Design by QuarzZ on MakerWorld (license: BY-SA).