Mechanical Pencil (0.7mm)

This mechanical pencil was modelled in Fusion 360, after I tried a some other models of mechanical pencils, and none working! This is made for specifically 0.7mm lead, have not tested it with any other kind, but with some modifications it may be possible. The lead comes out, and retracts smoothly, with the hole being the perfect size. You may print it multi coloured, or all in one colour.

All print settings that are needed have been applied in the print file, modify at your own risk!

Note:

For this pencil to work, you will need the inside lead mechanism of a 0.7mm lead, PEN+GEAR pencil. The pencil you get it from needs to be a specific one, which is shown down below. 

Pencil to take mechanism from:

What the mechanism should look like:

Assembly:

Step 1: Superglue the 2 pieces of the tip together, with the textured side of the base facing down. (I used hotglue, but superglue is recommended)

Step 2: Insert the lead mechanism into the bottom of the body. (The top of the tube should be going first into the hole on the threads of the body)

Step 3: After the tip has dried, thread it onto the body

Step 4: Friction fit the top clicker into the tube at the top of the body

Step 5: Insert your lead through the hole in the clicker, then put in your eraser, then done!

Any questions? Feel free to leave a comment or message me!

Design by AidenTua on MakerWorld (license: BY).