Meta Quest 3 Rugged Carry Case with Charging

OK!

The intention of this box was to build the ultimate home for my quest and its accessories.

It has a 20,000 mAH battery pack with 65w charging so it not only charges the battery for the quest and the controllers but it also charges my laptop and phone.

The print profile I have used has ironing dialed in for my x1c and it does take a little (lot) longer to print but it gives a great result. maybe you don't care so much and can save yourself some print time by turning it off.

Theres one sketchy overhang on the main box. I've printed 6 of these so far and i've had to remove a little rubbish but its hidden and it all works great. Don't use supports.

List of bits I've used.

USB Hub X 1

Female USB C X 1

HeatSet Inserts X 8

Cygnett Battery Pack x 1 (I've made the box to fit this unit maybe others will fit but this is spot on)
 

Assorted Screws

M3x20 X 8

M3x4 X 8

Cable for internal charging (right angle) X 1

USB Charging AA Batteries (4 Pack) 2 for the controllers and 2 on charge.

I think that's everything.. Good luck!

Design by TheTimminator on MakerWorld (license: BY).