Mini 13 PLA - Easy Print Action Figure

Summary

Introducing Mini 13 PLA!

Mini 13 PLA is an optimized version of the MINI 13 figure, optimized for PLA and other weaker filaments!

v4.2 Updates

- Fixed issue with frame where armor and accessories would fit too tightly

- Removed print artifacts

- Better build plate adhesion

NOTE: DO NOT USE THE “MIGHTY 13 REPAIRED” PRINT PROFILE! While it worked well for older models, (props to sonjamichelle) it has no hole in the frame for armor and is based off a much earlier version of this model.

v4.1 FIXED Updates
-Much better joint cycle life, especially in the middle body
-Fixed issue with hands' thumbs snapping off
-Removed Print Artifacts

v4 FIXED Updates
-Added True parity with all Mini 13 Accessories
-Improved Joint Longevity
-Better Fit w/ Armor

v2/v3 Updates
-Streamlined the entire design (eliminated overhangs, closed holes, etc)
-Fixed error with accessories not fitting

This starter set contains everything you need to start printing, playing, and making it your own. You can find the MINI 13 figure I based this model off of below:

Print Settings

Printer: 

Doesn't Matter

Adhesion:                  

Skirts recommended

Supports: 

No

Resolution:                      

0.2mm or Lower

Infill: 

20% - 80%

Filament:                                     Doesn't Matter (PLA, ASA, PETG, ABS, or Nylon)                                       
                        

Notes:                     

You may need to tweak these settings and find what works best with your printer.

Design by 3DM Prints on MakerWorld (license: BY).