One Night Ultimate Werewolf - Card Sleeves

Card sleeves for One Night Ultimate Werewolf

Unfortunately overtime the cards get worn and visible marks start appearing on the cards, unfortunately this means observant players can distinguish the type of card based on their unique wear marks.

These card sleeves have been designed with the intention of hiding the cards within the sleeve to prevent “cheating” by looking for these wear marks.

I have included an image of the werewolf on the front of the card sleeve for aesthetic purposes, this however creates a challenge to print.

Included are two print profiles:

1: Werewolves are printed face down onto the plate, producing a cleaning image (especially on a textured plate). This means that support material is required inside the sleeve which can be tricky to remove.

I found running a knife in-between the support material inside the sleeve to separate it from the model on both sides of the support, then using needle nose pliers to twist / push the support material works well. If you cause any split / cracks along the side of the sleeve this can be joined back using glue or a hot knife / soldering iron.

2: Werewolves sleeves are printed on edge, meaning no support material is required except for a brim at the bottom edge, this is the easier option requiring less post work, but takes a lot longer due to number of increased filament changes.

Design by Andrew on MakerWorld (license: BY).