OpenLock floor risers
OpenLock floor risers
- Made to order — 3D printed after you buy
- Free shipping on orders over $25
- Quality checked before it ships
- Questions? Contact us · Returns
These are a set of floor supports for OpenLock primary floor tiles. The supports are designed to stack if required enabling them to be combined if required.
These currently support OpenLock floor tile sizes E, R, S and U.
Each support comes in four different heights for the following purposes: -
- 1-inch - Underside of a tile will be at the top of a low wall
- 2-inch - Underside of a tile will be at the top of a full 2" wall
- 18mm - Top of the tile base is in-line with a low wall
- 37mm - Top of the tile base is in-line with a full 2" wall
The supports are compatible with the OpenLock v7.6 bases.
Note The pegs on each support may obstruct one of the end Triplex connectors on each edge, however, for most orthogonal connections between tiles this should not be an issue.
Original inspiration was taken from https://www.thingiverse.com/thing:3020197 but I needed them to work with OpenLock 7.6 and wanted full sides.
Design by 3D Print Workshop on MakerWorld (license: BY).