Pencil Case
Pencil Case
Simple pencil Case with build in sockets for vertical pencil and other small thing placement. Idea came from Mom of three kids and who am I to say it's not a great Idea :D.
Pencil case is a print in place model. No supports needed. As a locking mechanism I'm Using here four 6x2mm magnets as I didn't want to complicate model with latches and locks. In My opinion Magnets work very good. And to install them just use a very small pinch of supper glue and just be aware of magnet poles to install them in right direction.
Profile presented have 4 plates. Two versions of Pencil Case. Dual Color and single color. Both versions have two ways to print.
- Dual color - with mouse ear disks on all corners and without them
- Single color - with mouse ear disks on all corners and without them
As the printable area on built plate is quite large lift on corners is possible. So to make a bond stronger I do recommend to use them mouse ears. But if You are sure about built plate adhesion in your case you can use plates without them.
Unfortunately it came out a little bit too big for A1 Mini Printer so it is not compatible with A1 Mini in its original size.
You can Buy me a coffee if You would like to support me even more :)
https://www.buymeacoffee.com/warlogh
(And very Big Thank You For interest in my work)
Design by warlogh on MakerWorld (license: BY).