Ramp Walker Rabbit Toy w/glasses
Ramp Walker Rabbit Toy w/glasses
- Made to order — 3D printed after you buy
- Free shipping on orders over $25
- Quality checked before it ships
- Questions? Contact us · Returns
Loved this little rabbit toy from 无明业火_BLAZERS, but I felt like it needed the sunglasses to go along with all that attitude. I also add a little beveled edge to the tail but at the size you can't really tell so i may beef it up in the future.
Color by Layer Profile
First I set it up to color by layer to minimize poop, so it changes at layer 76 for the sunglasses and then back to white at 80 for the rest. So only two color swaps.
Painted Profile
This profile color swaps 4 times to only color the sunglasses, so more poop, but doesnt color the entire layer.
Obviously you can print it all in single color if you'd like though.
ORIGINAL ASSEMBLY INSTUCTIONS [translated] FROM DESIGNER
1. Required hardware: one stainless steel pin Φ2x16 (You can slide in a piece of 1.75mm filament for this though)
2. Anti-slip sticker: thickness 0.5mm, width 20mm, available on Taobao (or Amazon)
3. Assembly points:
A. After assembly, it must be ensured that the legs can rotate flexibly without jamming
B. Make sure the soles of both feet are parallel, otherwise the toy may not be able to walk in a straight line
C. Slope toys require the toy itself and the slope to complete the movement. Players need to adjust the slope angle by themselves to achieve the best effect
D. It is very important for slope toys to be anti-slip. To achieve the best effect, please try to use anti-slip stickers and rough slopes
Design by Ocular Dynamic on MakerWorld (license: BY-SA).