Snowflake Window Sticker

Here's some winter Snowflakes stickers I printed!

They don't require tape or glue.

just stick them to any clean/flat surface like a window or mirror, and voila instant charismas cheer!

Print/Install instructions

• Print with PLA
• Use on a clean textured PEI plate
• Try not to get hand oils on the build plate or the back of the prints
• Once the Snowflakes finish printing place the build plate in your fridge/freezer for a minute or so
• The Snowflakes should slide off easily, you shouldn't have to pry them.
• Clean the surface you want to stick them to then apply the Snowflakes, textured side to the window

Snowflakes sliding or falling off

Sometimes your Snowflakes won't stick

here's how you can fix that!

• Make sure the textured side is facing the window
• Ensure your Snowflakes, window, and build plate have been thoroughly cleaned
• Make sure the edges aren't curled or bent
• Not all filaments are the same I tested these with Bambu Lab's Jade White PLA
• If all else fails try printing them with one layer. To do so turn off “uniform scale” and change the Z from 0.4 to 0.2

Uncheck uniform scale

Change Z from 0.40 to 0.20

Inspired by @NUKDDD and their Fall Leaves Window stickers

Design by GuyFawkes on MakerWorld (license: CC0).