Staggerwing Biplane Holiday Ornament spinning prop

Biplane holiday ornament with spinning propeller! The default profile prints the prop in two sizes - 100% and 98%. This is a press to fit prop - if it falls out it's too small. If it's really not pressing it, trying printing slightly smaller - scale by 2-3% each time. Every machine and filament can be a little different. I also tried one filament where the plane was too tight to fit together, so there is a .04 spacing model if you run into that. You will need a little glue to hold the wings and horizontal on. A ribbon or string can run through the holes on the top wing, then right under the top wing mount. It's nicely centered when it's held up!

Design by kim on MakerWorld (license: BY).