The ultimate and optimized car phone holder!!

The original design was great but had some weak points.

This remix solves all of them!

1. thicker phone clamps - original clamps were too thin and broke very easily
2. wider phone clamps - if you have big smartphone and maybe with rubber cover, it could not fit in the original clamps.
3. reduced bolt tolerances - the original one was too wide, loosing screw grip making not possible to lock the phone in.
4. a narrower version of the air vent clamp is available so that you can choose which one best fits your air vents
5. added modifiers to enhance strength in weak points that used to break (vent clamp, and phone clamps)

This is the most optimized and advanced version available!

Little filament, great return!

PETG recommended since temperatures in the car can get high.

Pro tip!

After assembly, slightly melt the bolt ends to prevent the nut from falling off if over-unscrewed 😀

Design by pj_hack on MakerWorld (license: BY-SA).