Wall mount phone holder (Pro_Max_Ultra)

My version of Wall-mounted Phone Holder / Stand
It will fit any iPhone Pro (Pro Max), Samsung Galaxy Ultra - even with thicker phone-case. 
it can be used as desk stand but it has bit too sharp angle as it is suppose to be mounted high for standing person(less looking down),
 also if you put in really tall phone vertically it might get tipped over, but it does work fine horizontally on flat surfaces.
 

Features 2 holes (3mm + 5mm) on the back side for the screw mounting 
and 2 big holes on the front for ease of installation (with self tap screws right through or just mark holes first, 
pre-drill and screw in, easy 1-2min install)

The hole covers are there if you don't want to see the screws behind 

Lot of surface on the back if you want to use double sided tape instead of screwing them to the wall.
If you increase infill to 40-50% could be use as infill object. 
Prints without the supports just fine (see the images for close up image of the big hole to know if the “imperfection” is acceptable, tho the caps will cover it and are sized for no support print, if you print with tree support for the big holes,  the caps might end up bit loose).
 

(mine was printed with black mate pla and first prototype in the pic was infill object of white pla+ and matt black

Originally loosely inspired by 
https://makerworld.com/en/models/255226
- but it was missing something I could use to securely mount it to the wall 
- it needed to be printed with supports, (tho my version certainly uses more material)
- sharpen the angle of the “stand” is it's mean to be mounted close to head
- made the little recess in the bottom curve so phone doesn't slide out easily

Design by xxxAXAxxx on MakerWorld (license: CC0).