WWE Title Belt LED Lamp

WWE Title LED Lamp

This lamp was a total blast to design. The back lid for the title has a 10mm lip so you can run the LEDs around it and then install it all at one time. The stand is also done in two pieces to cut down on filament use.

Print Settings

.2mm layer height

2 or three walls for outside box

10%-15% infill for back cover

First Layer Flow Ratio: 1.04

Arachne

Wall transitioning threshold angle → 50º

Infill/wall overlap → 20%

Avoid crossing walls

Design by bearswampdesigns on MakerWorld (license: CC0).