X1 / P1 3D printer parts and accessoires drawer

I needed a neat and tidy solution to store my printer spare parts and some tools. I know I will add some parts in future so I made room for some extra pockets. I wanted this near my printers and the best way was to hang this below the desk (in my case Ikea Lack table).
This desk drawer maximizes the drawer size to the build plate and almost every space is used to store your parts and or tools that came with your printer.

I added two rails that can be attached under the desk easily that holds the drawer and has two stoppers at the end so the drawer will glide smoothly but cannot go to deep.
The rails need support to print and I have tried to keep the support to a minimum of waste but still enough to get good quality and stiffness.

The drawer has build in support because the maximum size doesn't leave room for automatic support. This two little support blocks are fixated to the drawer with only one layer to make sure it doesn't come loose during printing. These can easily taken out by forcing a screwdriver between the block and the drawer after printing.
The handle can be easily slid in the drawer front but will be snug so it will not come loose.

Happy printing and cleaning up your desk.

 

Design by L3xy on MakerWorld (license: BY-SA).