Bambu Carbon X1 Poop Chute System w Bin

Print a lot of multi-color? Tired of the poopies piling up behind your Carbon X1? So was I! Behold, the Poop Chute System! Rout the poopies through the benchtop, and down below into a large container for infrequent emptying. This system has worked flawlessly for weeks for me, and you almost forget that the printer is pooping at all. Set it, and (pretty much) forget it! Enjoy :)

Will require screws (M3 x 10) and a 3" hole saw. Remove the two small screws holding the Bambu Internal Chute from the back of the printer. The holes in the Printed Poop Chute align, insert and tighten the M3-x10 Screws to hold it all together. Position the chute directly above the table insert. You can rout the power cord through the provided slot(s) in the insert as well to plug in below bench for an even cleaner setup.

Design by Factotum on MakerWorld (license: BY).