Desktop photography multifunctional mirror car

Desktop photography multifunctional mirror car
The chassis and wheels are printed with PLA, and for the axles to ensure toughness, it is recommended to use PETG material. Through physical testing, the practicality is very good, and it can meet the small-scale use of various photography and lighting equipment. Special attention: The bearings used for the wheels and the nuts used for the shafts should be embedded inside the relevant parts using the temporary function of the layer to ensure integrity. When installing the wheel, the top surface of the bearing inside the wheel should be flush with the end face of the axle to prevent the wheel from rotating smoothly.

List of other required accessories:
Nut: M5 (thickness 3.7-3.9mm, tooth spacing 0.8mm, opposite edge length 8.75mm, diagonal length 8.79), 2 pieces
Screw 1: M5 * 20 (screw data in the picture: umbrella head screw, head diameter 11.5-12mm, head thickness 5mm, umbrella head step thickness 3mm), 2 pieces
Screw 2:1/4 camera specific screw (screw head diameter 12mm)
Bearing: 608-2RS, 4 pieces
Gasket: Nylon M6 * 10 * 0.5 (installed on the contact surfaces of each component depending on the situation)
Wheel rubber band: outer diameter 50mm, wire diameter 3-5mm

桌面摄影多功能运镜小车

底盘、车轮采用PLA打印，车轴为保证韧性，建议使用PETG材料。通过实物测试，实用性非常好，能够满足各类摄影器材、灯光设备小范围运镜使用。特别注意：车轮使用的轴承和轴杆使用的螺帽，利用层暂定功能，嵌入相关零件内部，确保完整性。安装车轮时，车轮内轴承顶面应与车轴端面平齐，以免车轮转动不畅。

所需其他配件清单：

螺帽：M5（厚度3.7-3.9mm、牙距0.8mm、对边长度8.75mm、对角长度8.79）,2颗

螺丝1：M5*20（图中螺丝数据：伞头螺丝，头径11.5-12mm，头厚5mm，伞头台阶厚度3mm），2颗

螺丝2：1/4相机专用螺丝（螺丝头直径12mm）

轴承：608-2RS，4颗

垫片：尼龙M6*10*0.5（各零件接触面视情安装）

车轮皮筋：外径50mm，线径3-5mm

Design by Fhitman711 on MakerWorld (license: BY).