Dovetail Jaw PITTSBURGH 4 in. Ratcheting Bar Clamp

Replacement for the upper jaw of the PITTSBURGH 4 in. Ratcheting Bar Clamp/Spreader to allowed it to be used in the same 14 deg dovetails as the other parts. When printed from standard PLA allows for light pressure clamping in the dovetail slots.

Requires one 4mm x 10mm bolt (Maker's Supply suggestion added)

In order to install the part

• Remove upper jaw by unscrewing the large dial, like if you were going to change it from a clamp to a spreader
• Place the new clamp head on the bar (it will be a tight fit) and attach by screwing bolt through hole

While not the most robust clamp it is extremely useful to be able to change a boatload of cheap clamps into dovetail clamps when needed.

Design by Pagedout on MakerWorld (license: BY).