Dragon Skull - Stability Remix

Loved this design from Printed into Existence, but it never sat stable on flat surfaces.

I've sliced off the bottom and set the jaw to 100% infill to improve the stability of the design for display on desks or shelves without a stand.

Supports near the back of the skull have been tricky to get right without using support material, which I know not everyone has access to, so the profile I've uploaded has my manual supports that I've found work best for me.

Updated Profiles

I've updated the profiles to use the new Crosshatch infill. They should have similar weights and print times compared to Adaptive Cubic, but Adaptive Cubic for some reason was occasionally causing Bambu Studio to write G-Code that had a layer shift for this model and only this model based on my testing.

Also note that these profiles are sliced with a profile for Numakers PLA+ that prints hotter than most other PLA's to create a glossy effect. I recommend using your own filament profiles or the stock profiles if you're not using Numakers filament.

Here's a referral link if you're interested in trying Numakers and would like a discount.

Design by JakeMakes on MakerWorld (license: BY-SA).