FNT stand for plates holder 5-25mm

Hello Makers! 

Discover the full FNT buildplates holder family here and explore all the ways you can build your perfect setup.

The FNT family includes:
– AMS plates holders for 4, 6, or 8 build plates
– “Stack” or standalone mountable holders for 4 or 8 plates
– Customizable plate logos
– TPU feet
– Adapters for AMS Raisers

How to use the stand? Simply use M4 nuts and screws to securely attach the stand to the holder body. Need more information? Please read :-)

FNT stand for plates holder 5-25mm

Introducing another accessory for the FNT Plates Holder!

This time it's a simple stand designed to elevate your holder (AMS or Standalone) by 5 to 25 mm. Choose the height that suits you best!

• P1S - If you need to place the AMS Buildplate Holder on top of the P1S printer's glass panel, you won't be able to use the fourth slot due to interference from the glass handle. However, raising the holder by just 5 mm solves this issue completely.
• X1/X1C/X1E - If you plan to install the AMS Buildplate Holder on the X1 printer, both the handle and the display may obstruct the holder when sliding plates out. In this case, we recommend using a 25 mm stand for smooth, hassle-free operation.
• Of course, this stand can also be used for other scenarios according to your needs.

Important Notice:
Don't forget to attach anti-slip pads to the holder. Before installation, ensure that the printer's glass surface is clean and the holder stands firmly in place without moving, even during printing. This precaution helps prevent accidental falls of the AMS from your printer.

The stand is fully compatible with the entire FNT series. The stand is fully compatible with the entire FNT series. On the bottom side, it features:

• Space for non-slip pads:
  • Silicone pads – round shape, up to 12 mm diameter, 3.5 mm thickness
  • Foam or rubber pads – round shape, up to 22 mm diameter, 2.5 mm thickness
• 8x Holes for neodym round magnets 8x3 mm
• 8x Holes for M4 screws

Printing instructions

• easy tu print
• PLA / PETG is OK
• layer 0.2mm, Supports: no, Brim: no

What non-pressing parts will you need?

• 4 or 8 pieces of M4 nuts
• 4 or 8 pieces of screws M4 type DIN7985 or simmilar (If you use countersunk screws, don't forget to use the included washers.)
  • The length of the screws will depend on your specific application. In general, you'll need screws approximately 5 mm longer than those currently used with your AMS/Stack holder (when using a 5 mm adapter), or screws 10 mm longer than your current ones (when using 10, 15, 20, or 25 mm adapters).
    • Example 1:
      When mounting a 5 mm adapter onto an AMS 4-plates holder:
      • AMS 4-plates holder uses 16 mm screws.
      • The adapter requires an additional 5 mm.
      • Recommended screw length: M4 × 20 mm.
    • Example 2:
      When mounting a 25 mm adapter onto an AMS 8-plates holder:
      • AMS 8-plates holder uses 30 mm screws.
      • The adapter requires an additional 10 mm.
      • Recommended screw length: M4 × 40 mm.

Assembly:

Simply use M4 nuts and screws to securely attach the stand to the holder body.

Design by Frantisek23 on MakerWorld (license: BY-SA).