Kids Modular Architecture Kit

Modular printable kids architecture kit. Creates any architecture and let your kid feels in his dream reality.

Sticks are 30cm long and the half version is available for smaller printers (despite I did not propose a profile).

Diagonal sticks are available to let you create more complex structures.

I created several connector versions as in the end they make the final result more beautiful, but in reality with normal sticks and full connectors you can do anything you want. I suggest you anyway to start by full and half connector, then test the rest.

At the very first time you place a stick in the hole you should apply more force, but thanks to this then the structure holds tightly.

PRINT SUGGESTIONS:

It prints with almost no support. Only support needed is for the small hole in the bottom, and only for 1 of the connector in the entire connector set.

For the connectors I used PLA, for sticks i tested PLA, ABS and PETG. I really discourage PLA meanwhile ABS is good for its strenght and you may probably build taller models. I chose PETG as i find it more flexible and can better resist to kids stress 5they were not able to kill any stick so far).

I did not use any glue for PLA connectors, nor for ABS/PETG sticks. Anyway beware that when you print sticks you shall not go too close to plate edge or the stick won't stick to the plate.

Design by IlMeo on MakerWorld (license: BY-SA).