I improved the creator's support to be able to adapt it better to my 17" MSI (it's not big enough), I widened the middle piece to have a good hold on the sides of my pc and I I made supports for the feet to have a better balance towards the back to prevent it from tipping over.

You must print 2*: Support_PC_Laptop_Foot support.stl

Dimensions:

• 17.2 cm width between the two feet, total width 22.5cm
• 2.5 cm widths of a foot, with a length of 19 cm
• 20 degree angle
• author at the lowest 6 cm

For assembly you can put hot glue to hold the pieces together

Creality

No

0.2 mm