Low-profile Keycaps SHORT FLAT REMIX - KLP Lamé

Love this keycap set by @braindefender and I initially set out to make a print profile for them at https://makerworld.com/en/models/197000-klp-lame-gateron-mx-keycaps. 

But I just couldn't get any to print reliably.

Thus the birth of the SHORT AND FLAT remix! I cut down the stem so it sits flat with the same level as the rest of the keycap, making them SHORT. This trades some keycap stability with a short stem for increased printability. 

To manage this, the stems are increased in width by 0.5% to create a tighter fit into my switches which have dust covers that hug the keycap stem.

*NOTE: the underside of the keycaps are UGLY after support removal. It does not impact their function however, so I don't care.

Despite advice that printing at 45 degrees and with 0.2mm nozzle would yield the best results, through much experimentation discovered that the surface quality is actually quite nice laid FLAT and printed with a good 'ol 0.4mm nozzle.

I only have included the ‘normal’ variants in both choc and mx stems rather than the ‘saddle’ style since I like them better.

Rather than populating a million different combinations of keys, each plate has one of each different key, so depending on your keyboard just choose the appropriate plate and increase the number of copies of each.

Design by Dropbear on MakerWorld (license: BY-SA).