magnetic latch for 3mm acryllic

I installed this on my enclosure by slipping the latch onto the acrylic sheet and marking where the frame magnets should be mounted (that's what the three smaller holes are for). After that, I simply used a 10mm drill on the frame and slotted the magnets so they were flush with the frame. I only used regular universal glue to fasten the magnets, and stuck a white sticker over both sets of magnets to clean up the look a bit (and to make it harder for the magnets to come loose in case the glue didn't work out).

Hardware needed
6 magnets (10x3mm)
2 M3x20mm screws
2 M3 nuts

Print settings

These are suggestions that have worked for me, mostly intended for people new to 3D printing. Other settings will probably work just as well or better, you know your own printer best. I have included my settings in the provided print profiles (the .3mf files)

Nozzle: 0.4mm
Walls: 3
Infill: 15 gyroid
Top and bottom shells: 5/3
Brim: yes
Supports: No
Filament: PETG or PLA 
 

Design by enbyvalent on MakerWorld (license: CC0).