Mazda MX5 Miata NC deep interior pocket/coin slot

I liked the idea of this deeper pocket by kishoderrek https://www.thingiverse.com/thing:4674650 however it had holes in it. I adjusted the model to remove the holes (to the best of my ability) for use in my partners car.

I printed it out with fuzzy skin but the bit you see most at the top still has obvious layer lines so realistically needs refinement after the fact for a proper look anyway. No clips but it holds in well and doesn't rattle. Adding those are a bit out of my skill set.

Best to print in PETG for resistance to heat though the one we are using currently is PLA which I expect to need to replace if it ever warms up in the UK.

Design by Pete on MakerWorld (license: BY).