Milwaukee Packout Rail bracket
Milwaukee Packout Rail bracket
- Made to order — 3D printed after you buy
- Free shipping on orders over $25
- Quality checked before it ships
- Questions? Contact us · Returns
This is a clean and simple Milwaukee Packout Rail bracket. It is probably the most cost affordable design out there as there are no addition screws, nuts, or extras to purchase.
Print Instructions:
Please print 1 at regular orientation AND 1 Rotated 180 Degrees so that when installed, the top pattern and bottom patterns are visually the same.
Materials List:
Lowes Item Number: (Model # 11317) 2in X 3Ft Interior/Exterior Mill Finished Aluminum Solid. Approx $15.00
Assembly Instructions: (Measuring for cut)
Since everyone's settings are slightly different, here is what I did to achieve the perfect cut for the aluminum bar
- Remove Milwaukee guide rod screw, and pull rods down, (no need to remove fully)
- Each 3D printed bracket (aluminum bar slot is 30MM) when measuring for the cut.
- Install 1 bracket
- slide aluminum bar into the other bracket (that's not yet installed)
- The Aluminum bar will extend past your other bracket, when you install make a mark on the aluminum bar where the bar meets the front part of the 3D part.
- Measure approx 25MM PAST your mark. (the 5mm difference is a buffer)
- Square a straight line, and cut the bar.
- Remove your installed bracket, install aluminum between both brackets, and reinstall into your Milwaukee Packout kit.
Sketch was done using Fusion360, Please remix to your preference. Please send / post pics of remix when finished.
Design by PLASTIC_MELD on MakerWorld (license: CC0).