Nozzle Wiper Brush Various Lenghts for X1C/P1S/P1P

This is a Remix of the amazing simple Nozzle Brush for X1C/P1S/P1P from franksj.

Since i bought a set of brushes that where 1,5mm to tall i created a set of remixes with different lengts

I used these Brushes (DE): https://www.amazon.de/dp/B095PJJZLF?ref=ppx_yo2ov_dt_b_fed_asin_title

but these Remixes should work with every 5mm brass wire brush with a 3mm (1/8") shaft

The brush sits the following increments lower:

1mm

1,5mm

2mm

2,5mm

You can print them all at once and then check the correct clearance

Added cause requested (only as STL):

3mm              

3,5mm          

4mm             

4,5mm           

I printed them in PETG and they came out great.

Design by Nupol on MakerWorld (license: BY).