Purge Line Cable Spine

Stop throwing away your waste! 

This modular cable spine is specifically engineered to use Bambu purge lines as structural "tendons."

You can save purge lines and print out more “vertebrae” to extend the cable protector.

Why is this useful?

• The vertebrae will protect your wires from being stepped on or crushed as they are inside of the protective cage
• You can put multiple wires together within the same system to keep them organized
• The system allows for wires to go in and out at any point, which allows them to be multi purposed, even for a shorter wire
• You can split the cables by putting the purge line through one side only and then adding a new one to the vertebrae

Key Features:

• Recycling Focused: Uses flat 1.75mm purge lines to keep the spine flexible and strong.
• Precision Fit: Designed for cables and any cord up to 8mm.
• Crunch-Tab Tech: Internal 0.8mm locking tabs "bite" into the waste filament to prevent sliding.
• Snap-Joints: 18mm peg and 18.2mm socket for a smooth, rotating friction fit.

Advice on use: 

The purge lines are easier to slide into the bottom of the pieces. In order to make the system go as long as you would like, stagger the purge lines on either side so that they aren't lined up equally. Add in a new line on either side when one runs out. The purge lines that will work the best are the middle part, which is very flat.

Design by Walter on MakerWorld (license: BY-SA).