Sy's Peglock - Irwin 1" Clamp Holder

Pegboard holder for Irwin 1" Quick-Grip spring clamps, compatible with standard 1" x ¼" hole pegboard.

There are 2 versions:

• 2x clamps (4 inches overall width, uses 2 pegs)
• 4x clamps (7 inches overall width, uses 3 pegs)

This design is based on the matching pliers holder, so either of these can be mounted next to either of those, in any order, without leaving horizontal gaps.

This uses Sy's Peglock System:

1. Print 2 or 3 pieces of the board attachment peg from here, in PETG at 100% infill, for best strength.
2. The holder may then be printed in PLA (or a material of your choice).
3. Fold each peg over on itself, then insert them into the pegboard, spaced to match the slots on the holder.
4. Slide the holder onto the pegs from above.

Design by vickash on MakerWorld (license: BY).