Test your 3D printer - 测试您的3D打印机

New version 3 here: https://makerworld.com/en/models/54359#profileId-56081

This is a hard to print testfile!
often you don't know if your printer is ready for complex files. with this file you have an easy option to check problematic printing/slicing stuff.

does your printer challenge this ultimative part?
check it out and get (almost) instant results.

these test are included in this tiny file:

• size: the object is 4x50x50mm (baseplate)
• hole size: 3 holes (3/4/5mm)
• Nut size: M4 Nut should fit perfectly
• fine details: pyramide, cone, all numbers
• rounded print: wave, half sphere
• minimum distance between walls: 0.1/0.2/0.3/0.4/0.5mm
• overhang: 25°/30°/35°/40°/45°
• bridge print: 2/3/4/5/6/7/8/9mm
• surface: all the flat parts

there could be a lot of things go wrong, here the most common ones

• your printbed is not leveled (should be better than layerheigth you're printing, e.g use a Micrometre)
• your axis (Y/X/Z) clearence (with higher speed you also get problems with the moving mass)
• your slicer and configuration (every slicer handles things different and could contain bugs)
• retract settings (not correctly set you will see blobs or holes on every retract position)
• to high temperature (small details will get overheated)
• to reach this time, your printer should run between 60-200mm/s, infill as fast as possible. not every printer works in this range, so try to figure out where you're printer limit is.
• text is hard to read > use a smaller nozzle/other slicer

Instructions

infill: 33% infill or similar
layerheight: choose the smallest possible layerheight. optimal 0.1mm or lower
print time: about 50 minutes, depending on your printer & settings. ) to reach this time, your printer should run between 60-200mm/s)

creation by ctrlV at Test your 3D printer!

Design by 3DPrintinGreece.gr on MakerWorld (license: BY).