Tripod Clamp for Alpha 3500

I designed replacement clamps for both the upper and lower clamps, though I have only tested the larger upper clamp myself. There is a small white piece of plastic between the clamp and the tripod leg. This piece is also required when using the new 3D-printed clamp.

I recommend ASA as the material, but I printed mine using eSUN's easyPA.

Print Settings:

• Support: Enabled
• Wall Loops: 4
• Infill: 70%

Assembly Instructions:
To remove the broken clamp, gently tap the pin out with a nail and hammer. When assembling with the 3D-printed clamp, position the tripod so the hole aligns with the edge of a workbench or similar surface to provide stability. Don't forget the small white plastic piece!

Design by Titus on MakerWorld (license: BY-SA).