Vehicle Sun Visor Extension
Vehicle Sun Visor Extension
- Made to order — 3D printed after you buy
- Free shipping on orders over $25
- Quality checked before it ships
- Questions? Contact us · Returns
Complete rework of IronGoober's “Car sun visor extension”. Added hard stops, knurled surfaces to grip the existing sun visor, resized to fit the X1 series build plate, and reduced overall thickness of the model. Not designed for any specific automobile, but it should fit most. Can modify upon request.
This was printed in PLA, which will not hold up well in a vehicle during the summer months. Recommend a more robust material with higher temperature resistance. 0.4mm nozzle, 0.2mm layer height. No support required.
Version 3.1 print profile in ABS should hold up in higher temperatures.
No additional hardware required.
Assembly
First, mate the Slide and Base together as shown in pictures. Then insert into the left and right rail-clips as shown. The interlocking keys are offset to ensure proper orientation. It is important to insert both the Slide and Base together into the end clips. Once the base is locked into a clip, the Slide can not be mated with the base. See Assembly .GIF
A drop of glue is optional on the six interlock keys. My make was tight enough without glue.
Revision History
V3 4/5/2025 - Initial Release
V3.1 4/6/2025 - Increased clip strength, new ABS print profile. 3.1 parts not compatible with version 3.0.
v4.0 7/13/2025 - Adds Side Extension. Find it here.
v4.2 9/15/2025 - Added print profiles for two 28mm diameter clips, 8° and 10°. Backward compatible with all versions. Use for thicker sun visors.
Close the Loop
Please post your makes, or comment/rate on print successes and/or failures to improve the design. Thanks!
Design by PuzMaker2024 on MakerWorld (license: BY).