Wall mount with outer frame for iPad Pro 2018

This is a two part wall mount to put that older iPad 2018 and those of the same dimensions to work as a hub for homekit. Mine is mounted in the kitchen. It uses a mount with relief for the back camera lens and a snap on frame to cover the power cable. A 90 degree cable USB-C is required and the frame has relief of the appropriate size to cover the power cable. The mount plate is printed in solid infill and attached to the wall with 3 screws. it is printed standing as in the 3mf file. It has the appropriate small tree supports manually placed for the rear camera cutout. The frame 3mf file uses lightening infill to be light and use less filament as it is just a decorative bezel to cover the iPad and through wall power cable. it had to be cut in to and slides together with dovetails. I did not glue it as none of the 3 prints I done needed glue. Its a tight precision fit on any full size Bambu printer. The joint is hardly noticeable once snapped over the mount. Both sides of the bezel also print standing and has an appropriate brim already in the 3MF file. I printed this setup 3 times to make minor adjustments twice. I cleaned the plate all 3 times and it printed perfectly all 3 time with PLA with nothing special except a 10mm brim and a clean plate.

Design by ShayneTroxler on MakerWorld (license: BY).